Architecture Panel

The Architecture panel appears in the MaStro sidebar tab when a Mass object is in Edit Mode. It exposes wall and floor type assignments at the element level.

Wall Type (Edge Select Mode)

When the mesh is in Edge Select mode, the panel shows:

Wall Type
A dropdown listing all wall types defined in the project. Assigns the selected wall type to all selected edges. The wall type carries thickness and offset properties used by Geometry Nodes to generate the wall geometry.

Flip Normal
Inverts the wall normal for the selected edges. The normal direction determines which side of the edge the wall thickness is applied to.

Floor Type (Face Select Mode)

When the mesh is in Face Select mode, the panel shows:

Floor Type
A dropdown listing all floor types defined in the project. Assigns the selected floor type to all selected faces.

---

Note

Wall types and floor types are defined in the Properties editor under Project Data → Architecture. See Properties — Project Data for the full list of controls.